Ignition Module
GA2344

Test notes: """Pick-up Coil"" Modules - this module needs an Auxiliary Coil to generate a magnetic signal that will drive the internal coil of the module, needed to generate the spark. To perform the test, follow the procedure below: • Connect the Auxiliary Coil cables between the ""NEG"" and ""R/EXT"" outputs of the coils section as shown in the image below. • Connect the module testing harness (RM02) as indicated on the instructions. • Activate the Modules/Coils test section and place the tip of the Auxiliary Coil into the module opening and then the spark could be seen in the spark gap."

Signal type: Magnetic

Product info »
Compare

Compare up to 3 products

Preloader