Ignition Coil
GC4562

Number of outputs: 1

Test notes: This coil has an integrated ignition module and the connector's “IN” pin controls the coil's high voltage output. To perform the test, follow the procedure below: • Connect the red cable from the modules test harness (RM02) to the “B+” pin on the coil, the black cable from the harness to the “B-” pin and the orange cable to the “IN” pin on the coil • Connect the high voltage cable from the equipment to the high voltage output of the coil • Select the Hall type signal (2) in the Modules/Coils test section, activate this section and observe the spark gap. There must be a spark on an electrode, indicating the correct functioning of the coil • Disable the Modules/Coils test section to end the test

Product info »
Compare

Compare up to 3 products

Preloader