Bobina de Ignição
GC4000

Quantidade de saídas: 1

Observações de teste: This coil has an integrated ignition module and the connector's “IN” pin controls the coil's high voltage output. To perform the test, follow the procedure below:• Connect the red cable from the modules test harness (RM02) to the “B+” pin on the coil, the black cable from the harness to the “B-” pin and the orange cable to the “IN” pin on the coil• Connect the high voltage cable from the equipment to the high voltage output of the coil• Select the Hall type signal (2) in the Modules/Coils test section, activate this section and observe the spark gap. There must be a spark on an electrode, indicating the correct functioning of the coil• Disable the Modules/Coils test section to end the test

Informações do produto »